![]() |
Upholstery Cleaning |
|
Standard Office Product Lines |
| Our fabric covered rests may be easily cleaned using standard
upholstery cleaners. Our experience has show that Lustre-Clene tm rug and upholstery cleaner is very effective at removing common ink and coffee stains. It is available from us in 1/2 oz. packages (Approximately 40 applications). Use 1/8 teaspoon per 1 oz. warm water. Using a soft bristle brush work up suds. With brush full of foam work foam into fabric over spot. Use a back and forth motion to remove stains. Wipe off foam and dirt with a clean, damp cloth. Part number UC1@ $ 2.00/pkg. Click here to go right to our online ordering system for Lustre Clene.
|
Vinyl Industrial/Medical Product Lines |
| Our vinyl covered industrial/medical rests may removed
by using the following cleaning methods:
|
|
| Light soiling: A solution of 10 percent household liquid dish soap with warm water applied with a soft damp cloth. If necessary, a solution of a liquid cleanser and water applied with a soft bristle rush. Wipe away the residue with a water dampened off. Disinfecting: Dampen a soft white cloth with rubbing alcohol and rub gently. Other disinfectants may be applied using this same process. Rinse with a water dampened cloth to remove any remaining rubbing alcohol concentration. |
Heavy soiling: Dampen a soft white cloth with lighter fluid (naptha) and rub gently. Rinse with a water dampened cloth.
For more difficult stains: Dampen a soft white cloth with a solution of household bleach: 10 percent bleach, 90 percent water. Rub gently. Rinse with a water dampened cloth to remove bleach concentration. If necessary bleach concentration can be increased to remove stains. |
| Note: to restore luster, a light coat of spray furniture wax may be used. Apply for 30 seconds and follow with a light buffing using a clean white cloth.
|
|
ESD and Clean Room Applications ESD and Clean Room Applications |
| Our vinyl covered ESD/Cleanroom rests may removed by
using the following cleaning methods:
|
| These products are covered with high quality, black vinyl that has a thin conductive coating. (Surface resistivity <1.0 x 10 to the 6th power ohms/sq.) Extreme care should be used when cleaning these products to avoid damage to the conductive coating. Warm water and a soft cloth are recommended. |
For more information, contact:
R&D Ergonomics Inc., 6 Harvey Brook Drive, Freeport, ME 04032
TEL: (800)-813-7274 FAX (636)773-0951 Email: info@MorencyRest.com